Hongsen products / Product structure and use
Screw-Control Bike Repair Stands and the HS-X006 Workstation
See how HS-X006 separates clamp screw control from upright height adjustment, with a nearby tool tray and a braced floor base.
The HS-X006 uses a hand screw to bring its clamp jaws towards the bicycle tube. Its upright has a separate height joint, so closing the clamp and setting the work position are separate operations. This layout suits buyers who want a manual bicycle repair stand with a clear distinction between the bicycle contact point and the stand adjustments.
The HS-X006 product has a steel, ABS and nylon construction. Its stated product size is 100 x 60 x 120-188 cm. The complete stand combines an upper clamp with a central upright and a spread floor base.
The clamp screw and upright joint have different jobs
The blue hand knob above the jaws operates the threaded clamp mechanism. The thread passes through the upper assembly towards the lower jaw. Turning a screw gives the operator control over the jaw position as the contact faces meet the selected tube.
The shaped blue faces form the bicycle contact area. The bicycle manufacturer’s guidance determines which tube can take that contact and the permitted clamping force. A wide-looking jaw alone cannot establish that requirement.
A second blue knob sits lower on the upright at the joint between its tube sections. This joint sets the upper assembly’s height. The operator can therefore choose a working position without treating the clamp screw as a height control. The horizontal arm also places the clamp away from the upright, leaving a gap between the bicycle contact point and the stand column.
A tray close to the work position
The tray surrounds the upright below the upper tube joint. Its shallow compartments give small parts a place near the bicycle, while the holes and edge openings offer separate tool positions. Keeping a removed fastener in a tray compartment separates it from tools resting alongside it.
The floor legs spread from the lower column, with braces joining them back to the central assembly. Those legs occupy the floor around the work point. A workshop layout should leave a walking route outside their ends and enough room to turn the bicycle’s cranks during the intended service task.
Browse the repair stand range to compare other work positions. For a manual station based on this screw-control arrangement, ask Hongsen about HS-X006 with the bicycle type and intended service work.