Floor-Standing Vertical Bike Storage with HS-T013WX

Hongsen HS-T013WX stores a bicycle vertically on a floor-standing structure. The rear wheel sits in the stand while the front wheel rises above it. A buyer can therefore choose an upright storage form with its support at floor level, distinct from a wall hook that hangs the bicycle by the front wheel.

The T013WX combines a tall tubular loop with two contoured wheel supports. Their relationship to the rear wheel explains how this model organises the parked bicycle.

Two contact positions along the rear wheel

The lower part of HS-T013WX extends between two floor crosspieces. A contoured support sits across this lower section, with another higher up between the two sides of the tall loop. Both have a narrowed middle and wider outer ends.

In the installed arrangement, the rear tire sits between these contact positions. The tall loop follows the wheel upward while the base stays beneath it. The bicycle’s front wheel is raised, so most of its length runs upward from the parked rear wheel.

For a buyer comparing wheel-based stands, the important difference is the complete bicycle position. A conventional floor parking stand keeps both wheels near floor level. The T013WX uses a floor structure while placing the bicycle upright. Its two separated wheel contacts and raised loop belong to that vertical arrangement.

Plan an upright floor position

A vertical bicycle still has handlebars, pedals and a route into storage. Set the intended position using the complete bicycle rather than the base alone. The front wheel and handlebars need clear height, while the pedals and rear-wheel area need space around the floor position.

The T013WX installation view shows a bicycle with its rear wheel at the stand and its front end raised. This gives a dealer a clear product-use illustration for a vertical storage range. It also shows which end of the bicycle belongs at the stand, a distinction that can disappear in a photograph of the empty product.

Choose the support form for the range

HS-T013WX is relevant when the required product is a floor-standing upright bicycle holder. A folding wall wheel hook such as HS-T009B uses another contact arrangement, with the front wheel hanging at the wall. The two products share a vertical bicycle position while locating their supporting structure differently.

Keep that difference clear in a product selection or dealer catalogue. The T013WX stands around the rear wheel at floor level; the T009B connects the front wheel to a wall-mounted hook. Explore the Hongsen storage and parking range, or contact Hongsen to discuss the floor-standing vertical form for your bicycle storage range.