Can a Floor Bike Stand Hold the Front or Rear Wheel? HS-T013CF

Hongsen’s HS-T013CF is a floor stand arranged to accept either the front or rear wheel while the bicycle stays in its normal riding orientation. For a buyer choosing a display or parking stand, that choice changes which end of the bicycle sits next to the stand and which end points into the available space.

The steel stand has two floor crossbars, a low wheel support and an upright frame with two hooks. The hooks fit through holes at different heights on the upright. The 2026 catalogue lists a maximum of 30 kg and a size designation of 16–29 inches × 2.6 inches. Check the intended bicycle and tyre against the current product specification when placing an enquiry.

Choose the wheel for the direction of the bicycle

With the rear wheel at the stand, the bicycle points away from the upright with the handlebars at the far end. With the front wheel at the stand, the saddle and rear wheel face away from it. This distinction helps a retailer plan which side of a displayed bicycle faces customers and where the handlebars will sit relative to a walkway.

The stand and the complete bicycle each need space. Measure the intended position with the target bicycle in its proposed direction, including its handlebar width and the space needed to put it in and take it out. The floor crossbars mark only the stand’s own contact area; they do not describe the footprint of a parked bicycle.

Set the hooks for the wheel

The lower section supports the wheel near the floor, while the two hooks are positioned higher on the upright. Their mounting holes allow the hooks to be placed at different heights. This arrangement lets the buyer consider the wheel’s diameter and the position of the tyre against the upright as part of the stand setup.

Wheel diameter and tyre width describe different dimensions. A bicycle can have a wheel diameter within the catalogue’s listed size while its tyre or nearby components still need a fit check. Use the intended bicycle to confirm the wheel sits properly in the support and that the hooks can be positioned for it. Follow the supplied instructions for assembly and adjustment.

What a buyer should specify

For a product range that needs a floor stand for a single bicycle, specify the intended bicycle size and whether the display layout calls for front-wheel or rear-wheel positioning. The two options change the direction of the same bicycle; they do not change the number of bicycle positions in the stand.

See the HS-T013CF product page for the model, or browse the storage and parking range. Contact Hongsen with the target bicycle and parking layout to discuss the model.